Cleaning for Whirlpool Air Cleaner WP-AP510:
A. Release tabs
B. Controls
C. Front grille
D. Pre-filter
E. HEPA filter
F. Bottom slot
G. Mainframe assembly
- Press POWER to turn off the air purifier.
- Unplug air purifier or disconnect power.
- Place fingers on the front release tabs. Gently push the tabs in and pull the front grille forward to remove it.
- Remove both filters and set a side. Do not try to wash and reuse either the HEPA filter or the pre-filter.
- Clean the air purifier with a soft, damp cloth.
- Gently wash the front grille in soapy water. NOTE: The grille is not dishwasher safe.
- Reassemble the filters as shown in previous illustration.
- Place the bottom tabs on the front grille into the bottom slots in base of the air purifier. Push the top of the grille forward until the grille locks into place.
- Plug in air purifier or reconnect power.
- Press POWER to start the air purifier.
Air purifier will not run:
- Is the air purifier turned on?
- Is the power cord plugged into a grounded 3 prong outlet?
- Has a household fuse blown, or has a circuit breaker tripped?
- Replace the fuse or reset the circuit breaker. If the problem continues, call an electrician.
- Was a regular fuse used? Use a time-delay fuse or time-delay circuit breaker.
AIR PURIFIER SAFETY
INSTALLATION REQUIREMENTS
Electrical Requirements
Location Requirements
AIR PURIFIER USE
Using the Controls
AIR PURIFIER CARE
Filter Replacement
TROUBLESHOOTING
ASSISTANCE OR SERVICE
In the U.S.A. and Canada
Replacement Filters
Quiet 30-Day Money-Back Guarantee
WARRANTY
Download here: Whirlpool Air Cleaner WP-AP510 User Manual & Troubleshooting
Sponsored Links: